Master Lock XR20 Wartungshandbuch PDF herunterladen (Seite 64)

pending triggered level is a stored current value that is transferred to the power supply output

when a trigger occurs. A pending triggered level is unaffected by subsequent CURR commands

and remains in effect until the trigger subsystem receives a trigger or is aborted with an ABORt

command. In order for CURR:TRIG to be executed, the trigger subsystem must be initiated (see

INITiate).

CURR? and CURR:TRIG? return presently programmed immediate and triggered levels. If no

triggered level is programmed, then the CURR level is returned for both values. CURR? MAX

and CURR? MIN return the maximum and minimum programmable immediate current levels.

CURR:TRIG? MAX and CURR:TRIG? MIN return the maximum and minimum programmable

triggered current levels.

Command Syntax: [SOURce]:CURRent[:LEVel] [:IMMediate][:AMPLitude] <NRf+>

[SOURce]:CURRent[:LEVel]:TRIGgered [:AMPLitude] <NRf+>

Examples: CURR 200

CURRENT:LEVEL MIN

CURRENT:LEVEL:IMMEDIATE:AMPLITUDE 2.5

CURR:TRIG 20

CURRENT:LEVEL:TRIGGERED 20

Query Syntax: [SOURce]:CURRent[:LEVel][:IMMediate][:AMPLitude]?

[SOURce]:CURRent[:LEVel] [:IMMediate][:AMPLitude]? MAX

[SOURce]:CURRent[:LEVel] [:IMMediate][:AMPLitude]? MIN

[SOURce]:CURRent[:LEVel]:TRIGgered [:AMPLitude]?

[SOURce]:CURRent[:LEVel]:TRIGgered [:AMPLitude]? MAX

[SOURce]:CURRent[:LEVel]:TRIGgered [:AMPLitude]? MIN

Returned Parameter: <NR2>

Related Commands (for CURR): *SAV, *RCL, *RST

Related Commands (for CURR:TRIG): ABOR, CURR, *RST

4.3.1.4 CURR:PROT

This command sets the over current trip (OCT) level of the power supply. If the output current

exceeds the OCT level, then the power supply output is disabled and the Questionable Condition

status register OC bit is set (see Table 4.2). An over current trip condition can be cleared with the

OUTP:PROT:CLE command after the condition that caused the OCT trip is removed.

CURR:PROT? returns presently programmed OCT level. CURR:PROT? MAX and

CURR:PROT? MIN return the maximum and minimum programmable OCP levels.

Command Syntax: [SOURce]:CURRent:PROTection[:LEVel] <NRf+>

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 128 129

Keine Kommentare

Master Lock XR20 Wartungshandbuch Seite 64