Master Lock XR20 Wartungshandbuch PDF herunterladen (Seite 65)

Examples: CURR:PROT MAX

CURRENT:PROTECTION:LEVEL 145E-1

Query Syntax: [SOURce]:CURRent:PROTection[:LEVel]?

[SOURce]:CURRent:PROTection [:LEVel]? MIN

[SOURce]:CURRent:PROTection [:LEVel]? MAX

Returned Parameter: <NR2>

Related Commands: OUTP:PROT:CLE, *RST, *SAV, *RCL

4.3.1.5 PER (not available for XR Series power supplies)

This command sets the period of time that the power supply will remain in the state during auto

sequence operation. The minimum unit for the period command is 10 msec and the maximum

unit is 9997 sec. There are 3 reserved numbers associated with this command, namely: 0, 9998

and 9999. When a 0 is detected in auto sequence operation, the power supply will stop as if a

stop command condition (see OUTP:STOP) occurred. When a 9998 is detected, the following

memory location will be zero. When 9999 is detected, the power supply will operate at that

memory state indefinitely or until stop (see OUTP:STOP) is commanded. The period’s duration

can be overridden by the using the start command (see OUTP:START) to advance the memory to

the next state or the stop command OUTP:STOP) to stop the power supply.

PER? returns the period at the current memory.

Command Syntax: [SOURce]:PERiod <NRf+>

Examples: SOUR:PER 200

SOURCE:PERIOD 1345

SOUR:PER MAX

Query Syntax: [SOURCE]:PERiod? <>

[SOURCE]:PERiod? MIN

[SOURCE]:PERiod? MAX

Returned Parameters: <NR1>

Related Commands: *RST, OUTP:START, OUTP:STOP, OUTP:ARM

4.3.2 Measure Subsystem

The Measure Subsystem returns the voltage and current measured at the output of the power

supply.

4.3.2.1 MEAS:VOLT?

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 128 129

Keine Kommentare

Master Lock XR20 Wartungshandbuch Seite 65